Buying a used jet ski? Don't gamble on what's under the hood. Our certified techs inspect any PWC before you hand over the cash using manufacturer-grade computer diagnostic software — compression, hull, jet pump, electrical, and full history review. Mobile service across Long Island.
A thorough walkthrough of every system that can cost you thousands if it's bad. Done at the seller's location or your driveway.
Cylinder compression test on every cylinder, oil condition, hour count vs. wear, signs of overheating or water ingestion.
Stress cracks, hidden repairs, gel coat issues, sponson damage, drain plug area, transom condition.
Impeller wear, wear ring clearance, drive shaft play, bearing condition — the most expensive overlooked area.
Manufacturer diagnostic software scan to pull fault codes and engine data. Battery health, starter operation, gauges and warning lights, MFD/display function, wiring harness condition.
Cooling lines, exhaust manifold condition, signs of salt or sand intrusion, intake grate damage.
Service history review, HIN (hull ID) verification, proper registration document verification.
Bunk condition, wheel bearings, tire age, light operation, frame rust, coupler and safety chains.
If conditions allow, we'll start the ski and listen, check water flow, RPM response, and reverse/iBR function.
Tell us the make, model, year, and where the ski is. We'll quote you based on the job and book a time.
Our tech meets you (or the seller) at the ski's location with all the right tools. Usually takes about an hour.
Same-day written report with photos, findings, and our honest recommendation: buy it, negotiate, or walk away.
